Friday, September 16, 2011

Vortex Praxis Mod guide

This mod is essentially the same mod you can do on the three spring powered Vortex blasters, and simply involves reconfiguring the spring to have more pre-load tension. Though, there are already guides on how to do this, this guide is more about how to access the spring in the Praxis easily.


So let's get started! first, disassembly:
First remove the stock and accessories. then have a look at the rear of the blaster and remove the two screws holding the stock adaptor on. Then go ahead and remove the 13 screws in the green part of the shell. You do not need to remove the screws on the barrel or the pump action grip.



You now have access to what you need. Remove the screw from the left side of the plastic plate housing the spring, and also the screw in the picture below, allowing you to pry that plate down. Now lift the cover plate off the pins that hold the firing arm and rubber stopper in place, and slide it left until it is free. The pictures below should help.


Below, you can see the plate is removed and there is clear access to the pins that hold the rubber stopper and firing arm in place. Use a pair of pliers to slide these out and take the firing arm out for now.


Now, all you have to do is unscrew the silver screw and move the spring position around to the left, and screw the silver screw back in there. originally, my Praxis had the spring set in the centre position, and now uses the left-most position to apply more pre-load pressure.


Re-assembly is as simple as reversing the steps to disassemble. you will now have an increase in disc speed and a little more range. Hope this helps!

7 comments:

  1. Very nice! This is indeed a simpler way to access the firing mech. Thanks for the guide!

    ReplyDelete
  2. Followed this mod guide, very simple, quick but effective. Now my Praxis is one of my favourite blasters. Thanks mate!

    ReplyDelete
  3. Thanks for the guide, I have an issue though, hopefully you can help me. When I pried open that little tab my stopper and spring came out and now I dont know how it goes back in. Can you help???

    Thanks in advance

    ReplyDelete
    Replies
    1. Hey, send me an email to the email address listed on the about page, with some pictures and as much detail as you can and I will try to find some time to open up mine tomorrow and write you a repair guide with some pictures for you.

      Delete
  4. Will do, thanks so much!

    ReplyDelete
  5. got any other mods that don't involve screwing for the praxis? thanks

    ReplyDelete
  6. simple, but it is hard to move the metal thing.

    ReplyDelete